Serial Communication Control
In default working mode, the camera is able to connect to a VISCA controller with RS232C
serial interface.
➢
RS232 Communication Control:
The camera can be controlled via RS232 ,the parameters of RS232C are as follows:
Baud rate: 2400/4800/9600 bit/s.
Start bit: 1 bit.
Data bit: 8 bits.
Stop bit: 1bit.
Parity bit: none.
➢
RS485 Communication Control:
The camera can be controlled via RS485, Half-duplex mode:
Baud rate: 2400/4800/9600 bit/s.
Start bit: 1 bit.
Data bit: 8 bits.
Stop bit: 1bit.
Parity bit: none.
Pan-Tilt will rotate to the maximum position of top right after the camera started, then it return to
the center, the process of initialization is finished. (Note: If the position preset 0 has been stored, the
position preset 0 will be called up after initialization) Then the users can control the camera with
commands in the command list.
PTZ over TCP/UDP Realize
A TCP server has achieved in camera, port number 5678. When the client has established a TCP
connection with the server, the client send PTZ control command to the server, the server parsed and
executed the PTZ command.
A UDP server has achieved in camera, port number 1259. Client to the server sends the PTZ
control command, the server parsed and executed the PTZ command.
