Cable assignment of your
RALLYE
MASTER
SPORT:
Red
Positive pole 12-14 volts with 1A fuse
Black
Earth vehicle
Brown
Positive pole sensor 5 volts
Green/Yellow
Earth sensor
Blue
Signal sensor
Please note:
As standard, the RALLYE
MASTER
SPORT distance counter is delivered
without a sensor. In general, only sensors with an operating voltage of 5V
are to be connected.
When using the VDO sensor
, a 3 kOhm resistor
must be connected between the blue and the brown cable of the
RallyeMaster.
If you connect another sensor afterwards, it might be possible that this
resistor has to be removed! For this purpose, please observe the
connection details of the respective sensor manufacturer.
Sensors that can be used:
For your RALLYE
MASTER
SPORT, different sensors / pulse generators
with two or three connection cables can be used:
•
speedometer cable sensors
•
wheel sensors
•
cardan shaft sensors.
Assembling your
RALLYE
MASTER
SPORT:
Fasten your RALLYE
MASTER
SPORT in such a way that the passenger
and the driver can clearly see the device.
Please make sure that the assembly is carried out in such a manner that
the device does not cause any additional risk of injury in the event of an
accident! The M4 threaded bushings at the top of the device are used to
assemble the distance counter.
Please do not use any screws with a
thread length of more than 15 mm!
Assembling the VDO sensor:
Connect Blue/Red to Blue RALLYE
MASTER
COMPETITION (signal sensor).
Connect Brown to Green/Yellow RALLYE
MASTER
COMPETITION (earth sensor)
Connect Black to Brown RALLYE
MASTER
COMPETITION (positive pole Sensor)