Prestan professional
AED TRAINER
COPYRIGHT 2012 PRESTAN PRODUCTS LLC
11
Rev. 101812
Trouble Shooting Guide
SYMPTOM
POSSIBLE ISSUES OR COMMENTS
SOLUTIONS
Module will not fit into
slot
•
The Module is designed to be inserted one
way only
•
Rotate the Module 180 degrees and it
will fit
Unit Does Not
Turn On
•
Module is missing or not fully inserted
•
Batteries are not property installed
•
Batteries are dead or are missing
•
Insert or Re-insert module properly
•
Re-orient batteries properly
•
Replace batteries
Difficult to Peel Off the
Pads Liner
•
Peel the liner from the Tab End
•
Gently bend over the Connector to start
separation
•
Peel with thumb if necessary
•
Remove and throw away liner
•
Refer to the Assembly Section
Both pads attached to
Manikin but
device will not advance to
Analysis
•
Operational solution
•
Pad is inserted upside down in the cable
connector.
•
Adhesive worn out
•
Insure Pads are being pressed on
firmly
•
Flip pad around and secure with black
pad pin
•
Replace pad
Pad pulls out from pad
connector
•
Check for black pad pin missing
•
Install new black pad pin
Lid will not stay closed
•
Pads Case is not placed in proper position
•
Re-seat pads case
•
Wires not properly stored in compartment
under Case - Wire may be caught under
edge of Pads Case
•
Re-coil the wires
•
Pads Case Front & Back not properly closed
•
Snap case together on all 4 corners
Device Proceeds to
Analyzing before
both pads have been
placed on the
manikin
•
Pads not properly positioned in Case
•
Look for pad riding up pad case wall
•
Re-position pad in case to lay
completely flat so it is not touching
side walls
