24
11) PRIORITY CHANNELS
Priority channels will be automatically
selected
by switching this key (
11
).
3 positions switch:
EMG1
/ Priority channel 1 is activated.
EMG2
/ Priority
channel 2 is activated.
OFF /
No priority channel is activated.
The default priority channels are channel
9/AM/band A
(
EMG1
) and chan-
nel
19/AM/band A
(
EMG2
).
See the
EMG SET 1
and
EMG SET 2
menus page 26 to
set
priority channels.
Note:
Activating a priority channel no longer allows you to change modula-
tion mode (AM or FM), to start the
SCAN
function or activate the
PA
mode.
If the
KEY BEEP
function is active, an error beep is emitted.
“EMG”
and the
channel blink to indicate unauthorized handling. Turn the switch (
11
) to the
OFF
position to use these functions.
12) ECHO
Allows to
enable
/
disable
ECHO
function.
See menu
ECHO SET
page 28 for
ECHO
configuration.
13) MODE ~ PA
MODE
(short press)
Press
MODE
key (
13
) to
select
the modulation mode: AM or FM. Selected
mode is displayed on display.
Your modulation mode has to correspond to the one of your correspondent.
-
Frequency Modulation /
FM
: for nearby communications on a flat open
field.
-
Amplitude Modulation /
AM
: communication on a field with relief and
obstacles at middle distance (the most used).
PA
(long press)
Switch between normal and
PA
(Public Address) mode.
An external optional speaker can be connected to the unit to the PA.SP.
jack on the rear panel. (
D
). Turn the
MIC GAIN
knob (
4
) to adjust the
PA
volume.
For details on operating in
PA
mode, see the
PA SETTING
menu on page
27.
14) BARGRAPH
Indicates
the reception level and the emitted power level.
15) 6 PIN MICROPHONE PLUG
The plug is located on the front panel of the transceiver and makes the
setting of the equipment into the dashboard easier.
See Cabling Diagram page 74.
16) USB CHARGING SOCKET
The
USB
socket (
16
) can be used to charge smartphones, tablets or other
rechargeable devices with 5 V - 2.1 A.
17) PTT
Transmission key, press to
transmit
a message,
is displayed and release
to
listen to
an incoming communication,
disappears.
TOT (Time Out Timer)
If the
PTT
switch (
17
) key is pressed for more than 5 minutes, the display starts
blinking and the transmission
ends
. A beep will sound until the
PTT
switch
(
17
) key is released.
18) UP/DN BUTTONS ON MICROPHONE ~ SCAN
UP/DN BUTTONS ON MICROPHONE
(short press)
In normal use, press
UP
/
DN
buttons (
18
) on the microphone to
change
the
frequency.
UP
to
increase
and
DN
to
decrease
the frequency.
In
MENU
mode [press the
PUSH
knob (
6
) for about 3 seconds to activate this
mode
(see §
MENU
page 25)
], the
UP
or
DN
buttons (
18
) allow to
select
the menu to be set.
See
ROTARY “PUSH” KNOB
page 22
.
English
