20
Using Your Radio
Turning It On
Press and hold
POWER
for at least two seconds to turn the radio on. Press and
hold
POWER
again to turn the unit off.
Setting It Up
Even though you can change your radio’s settings at any time, you will prob-
ably want to establish initial settings after you have turned it on for the first
time. You will adjust some of these settings on an as-needed basis, but some
settings might only need to be set once.
Changing the volume
To change the speaker volume, press
VOL/SQ
to enter Volume Setting mode.
0
(for volume level 0 - 9) displays. Press
CHANNEL UP
or
CHANNEL DOWN
to increase or decrease the volume levels. Press
VOL/SQ
to save.
Setting the Squelch level
The PM-2050 SWF recognizes signals as transmissions if they exceed a signal
strength threshold.
Adjusting the squelch sets this threshold level. Increasing squelch requires a
signal to be stronger to be seen as a transmission. If you set the squelch too
high, you will risk not receiving transmissions that are lower than that threshold.
Reducing the squelch allows weaker signals to be accepted. However, if you
lower the squelch too much, you will hear white noise all the time.
Summary of Contents for PM-2050 SWF
