Page 12 of 20
Lay the four metal braces, as shown, with the bend resting
on top of the inner gables
STEP 10
Estimated Time: 5 minutes
10a
Find the pre-drilled holes on the inner gables and
secure the bent end of each metal brace to the inner
gables with the small black screw (#8 - 9/16”
Washerhead Screw).
10a
10b
Secure the other (flat) end of the metal brackets to U-channel.
Position the flat end of the
metal brace under the hole on
the BOTTOM edge of the U-
channel. Push the outer gable
toward the center of the bed
until holes line up.
Metal brace secured to
the U-channel
Insert machine screw through U-
channel and metal brace and
attach wing nut to the screw.
Insert a screwdriver through the
large hole while holding on to the
wing nut to tighten.
10a
10a
10a
10a
10b
10b
Bend
Pre-drilled hole
10a
10b
