Tip:
If the seat
back is a little
tight going into
the seat base,
partially loosen 2
of the seat
screws to allow
the base legs to
open, insert the
seat back and
then re-tighten
the screws.
Tip:
When installing the chair bolts in
Steps 6 & 7, insert the bolt into the
hole, align it with the nut and finger-
tighten the bolt a couple of turns into
the nut before driving with a drill. This
will help to reduce the risk of cross-
threading.
G
F
b
b
H
b
a
E
d
8.
Assemble Part E into the chair. Insert
the tenon into the slot in one leg. Then
with slight pressure on the opposing leg,
push the opposite side of Part E into its
corresponding slot. Screw in place using 2
of hardware d.
7.
Turn the back/seat assembly on it's
side. Lay one arm/leg assembly from
steps 1-5 on the back/seat assembly and
fasten using 1 each of hardware a & b as
shown. Lay Part H in place and fasten
with 2 of hardware b at the back, then 1
hardware b at the front.
Flip the chair to the opposite side and
repeat this process.
6.
Attach Part G to Part F using 4 of
hardware b.
4
AD-0111 Assembly
1-877-904-1234
www.Poly-Lumber-Furniture.com
