7
7.1 Operations
Time Adjustment
1.
Press “Switch” to alternate to time setting. Push the “+” or “-” button to adjust the
time setting. To increase the run time push the “+” button until desired time reached
or maximum of 60 minutes. (See section 6.1). To decrease the run time push the “-”
button until desired time reached or minimum of 1 min. (See section 6.1). If the
numbers above “TIME LED” are not Lit, make sure AC power cord is completely
plugged into socket.
Speed Adjustment
1.
Push the “SWITCH” button one time to adjust the speed setting. The 4 digit number
beside the word “TIME/SPEED LED” should change to rpm’s. (See section 6.1). If
the numbers above “TIME/SPEED LED” do not change to rpm’s, then continue to
push the “SWITCH” button until this happens.
2.
This centrifuge default setting for speed is in RPM’s. Please select desired speed
(shown in RPM’s) by using the “+” or “-” arrow buttons until the display panel reads
your desired settings.
Spinning Centrifuge
2.
Insert the centrifuge tubes in a manner that will balance the specimen tubes’ weight.
Always insert an even number of tubes on opposite sides of the rotor with
approximately the same amount of specimen in each tube.
Now that the desired time is selected, you can now run your samples.
1.
Make sure lid is closed and locked.
2.
Press the “On/Off” button, and centrifuge will begin spinning.
3.
After the centrifuge has run for the programmed amount of time unit will begin to
decelerate and come to a complete stop. Please note that the lid should never be
opened until centrifuge has come to a complete stop.
Note
This centrifuge lid is designed to automatically stop when the lid is open. If you have any
problems operating the centrifuge; Please contact your dealer or authorized provider.