Premier NV-4601, Instruction Manual

Page: 12 / 16

P-3
CALAMITIES.
INSTRUCTIONS FOR USE
1.WHEN OPERATING THE REFRIGERATOR FOR THE FIRST TIME, RUN IT WITHOUT LOADING ANY FOOD UNTIL IT
AUTOS TOPS AT THE DESIRED TEMPERATURE. USUALLY IT TAKES 2 OR 3HOURS,THEN SET THE
THERMOSTATIC DIAL AT THE SETTING DESIRED AND PUT FOODS IN THE REFRIGERATOR.
2.THE TEMPERATURE OF THE REFRIGERATOR CAN BE ADJUSTED BY TURNING THE THERMOSTATIC DIAL. A
MEDIUM SETTING OF THE THERMOSTATIC DIAL IS THE MOST SUITABLE FOR GENERAL OPERATION.
3.DEFROST THE FREEZING COMPARTMENT WHENEVER THE LAYER OF FROST ON THE SURFACE OF THE
EVAPORATOR REACHES 3 OR 4 MM. WHEN DEFROSTING REMOVE ALL FOOD AND SET THE THERMOSTAT AT
“OFF” POSITION. PUT THE DRIP TRAY UNDER THE EVAPORATOR TO COLLECT MELTED WATER. AFTER THE
FROST HAS MELTED, DISCARD THE MELTED WATER AND DRY UP THE INTERIOR OF REFRIGERATOR. THE
REFRIGERATOR CAN THEN BE RESTARTED BY TURNING ITS THERMOSTAT TO THE DESIRED SETTING.
CAUTIONS FOR USE
1.THE MORE FOODS TUFF PUT IN OR THE MORE AND THE LONGER FOR ONCE THE DOOR IS OPENED, THE MORE
IT NEEDS ELECTRIC CONSUMPTION, WHICH EVEN LEADS MALFUNCTION.
2.BETTER NOT TO PLACE THE OBJECTS WHICH ARE TOO HEAVY ,POINTED OR CORROSION ON TABLE BOARD.
3.RE-PLUGGING IN THE POWER PLUG AT THE INTERVAL OF OVER TEN MINUTES.
4.DON’T STORE BOTTLED DRINK IN THE FREEZER, SO AS TO PREVENT FROM BEING BROKEN AND DAMAGING
THE REFRIGERATOR.
5.OPEN THE DOOR AS LESS AS POSSIBLE DURING POWER-CUT.
6.WHEN DEFROSTING, NEVER USE ANY SHARP OR METALLIC OBJECTS TO REMOVE THE FROST ON THE
SURFACE OF THE EVAPORATOR AS IT WILL DAMAGE THE EVAPORATOR.
7.DON’T TOUCH FOODS AND CONTAINERS IN THE FREEZING COMPARTMENT WITH YOUR WET HANDS SO AS TO
PREVENT FROM BEING FROSTBITTEN.