1
4
3
Preparing the collar
Attach the spray device to the strap
Remove the keeper from the strap. (figure 1)
Orient the device so that the fill port and
spray valve are facing up and microphone
is facing you. (figure 2)
Grasp the strap in your right hand. Thread the
strap from front to back through the ear on
the right. Bring the strap around the back-
side and then thread it back to front through
the ear on the left.
Make sure not to cover
the microphone with the strap.
(figure 3) Put
the keeper back on the strap. The curved edge
of the keeper should face the inside.
Now it’s time to attach the quick-snap buckle
to the strap. Feed the free edge of the strap
into the slot that is closest to the center,
starting on the inside of the curve. Next, feed
the free end through the slot on the edge of
the buckle. (figure 4)
Pass the loose strap through the keeper.
Failure to do so will increase the likelihood
that the strap will slip causing a need to
constantly adjust the fit. The assembled
collar should look as shown. (figure 5)
Fill the spray reservoir with citronella
Steady the device on a flat surface with the fill port
facing up. Turn the spray can upside down and
place the nozzle in the fill port. (figure 6) Using
firm pressure, push down on the can and hold
for 15 seconds. Repeat and hold for an addi-
tional 5 seconds to fully fill the reservoir. If
spray is escaping as you attempt to fill, in-
crease the downward pressure on the can to get
a better seal.
You cannot overfill the device.
When
completely filled, there should be approximately 25
sprays in the reservoir.
Insert the battery into the
spray device
To insert the battery, remove the battery
door. Make sure the + on the battery lines
up with the + in the battery compartment.
(figure 7) Replace the battery door. The ON/OFF
switch (figure 8) is located at the bottom of the
device. If the battery is in and the device is
ON, it’s ‘listening.’ To prolong battery life,
make sure that you turn the device OFF
when it’s not in use.
Test the spray device
Before every use, it’s best to test the spray action
by turning it ON and blowing into the microphone.
figure 1
figure 2
figure 3
figure 4
figure 5
figure 6
figure 7
figure 8
