P-4
Connecting and aligning the transmitter
Attention: Position the transmitter with a minimum distance of 1 m to
other electronic devices, otherwise there is a risk of mutual disturbance.
Point the upper section of the transmitter towards the baby or object you want to monitor. Check
that the baby or object is suitably displayed on the receiver.
Operating with batteries (not supplied)
Use a small screwdriver to open the transmitter’s battery compartment
on the underside.
Insert the batteries, paying attention to correct polarity. Refer to the
diagrams in the battery compartment. Close the battery compartment
again.
The transmitter is operated by means of 4 AAA Alkaline batteries (not contained in the material
supplied). The transmitter cannot be charged.
Insert the batteries before connecting the power adapter plug.
In the case of a low battery charge, the Power LED flashes slowly. The batteries must be
replaced.
Operating with a power adapter plug
Connect the transmitter as illustrated in the diagram. For safety reasons, only use the power
adapter plug supplied.
Connecting the receiver
Attention: Position the receiver with a minimum distance of 1 m to other electronic devices,
otherwise there is a risk of mutual disturbance.
Operating with a power adapter plug
Connect the receiver as illustrated in the diagram. For safety reasons, only use the power
adapter plug supplied.
