4
Customer Care 1 (866) 381-2785
Setup Instructions
1. Rinse all of the fountain components
except for the adaptor plug and pump.
Disassemble the pump before using. Take
the pump apart by first removing the blue
faceplate. Use your finger to pull up on the
small tab.
Blue
Faceplate
Tab
1
Stator
Flow Control Knob
2
Pump
3
Flow Control Knob
Highest Flow
Lowest Flow
4
2. Remove the blue stator with flow-control
knob by pulling up on the small lip. Do
not throw this or any other part of the
pump away.
3. Use a fingernail to pull out the impeller,
which is held in place magnetically. Rinse all
of the pump parts before assembling.
4. Reassemble the pump by first inserting
the impeller. Then, replace the stator and
faceplate. Make sure the flow control knob
on the stator is in the correct position for
your desired flow rate.
NOTE:
If the flow is too strong or spraying
any water while it is running, try adjusting
the flow to a lower setting.
