premierpet.com
3
Fit the Collar
Important: The proper fit and placement of your In-Ground Add-A-Dog collar is important for
effective operation.
1. Start with the collar turned off and your dog standing comfortably,
not sitting.
2. Place the collar on your pet so that the Premier Pet
™
logo is right
side up and the collar is directly under your dog’s chin. Center the
contact points underneath your dog’s neck, touching the skin.
NOTE:
It is sometimes necessary to trim the hair around the contact points to
make sure that contact is consistent.
3. Check the tightness of the collar by inserting one finger between the
end of a contact point and your dog’s neck. The fit should be snug
but not constricting.
4. Allow your dog to wear the collar for several minutes, then recheck
the fit. Check the fit again as your dog becomes more comfortable
with the collar.
Do not shave the pet’s neck as this may increase the risk of skin irritation. The collar should not be worn for more than 12 hours out of
every 24-hour period. Leaving the collar on too long could lead to skin irritation.
Insert and Remove the Receiver Collar Battery
NOTE: Do not install the battery while the receiver collar is on your pet.
This receiver collar utilizes a replaceable battery (GAC11-16351). This
unique battery is designed to make battery replacement easier and
increase water protection.
To insert the battery, align the symbols on the battery (arrow) and
receiver collar (triangle). Use the edge of the test light tool to turn the
battery clockwise until the arrow lines up with the lock symbol on the
housing.
To remove or replace the battery, turn the battery counter-clockwise
using the edge of the test light tool. DO NOT attempt to cut into or
pry open the battery. Be sure to discard the used battery properly. When removing the old battery from
the receiver collar, discharge all power by holding the static level button down until the light is no longer
illuminated. Replace with a new battery.
Risk of explosion if batteries are replaced by an incorrect type. Do not short circuit, mix old and new batteries, dispose of
in fire, or expose to water. When batteries are stored or disposed, they must be protected from shorting. Dispose of used
batteries properly.
A replacement battery (GAC11-16351) can be found at many retailers. Contact the Customer Care Center
or visit our web site at premierpet.com to locate a retailer near you.
Set the Static Correction Level
Read all steps before attempting to set the static correction level.
1. Remove the clear plastic cover with the edge of the test light tool to
expose the correction level button.
2. With the battery installed, press the correction level button and release
when the receiver LED indicator light lights up.
3. The receiver LED indicator light will emit a series of flashes representing
the static correction level.
4. Increase the static correction level by pressing and releasing the correction
level button within 5 seconds of the previous series of flashes.
5. After setting the static correction level, replace the cover to protect the
correction level button.
The static correction levels increase in strength from 1 to 5. Pushing the
correction level button while the receiver collar is on level 5 will cause the
receiver collar to revert to level 1.
The receiver indicator light acts as a low battery indicator. The light will flash
every 4 to 5 seconds when battery replacement is required.
