UNI-PDS/UNI-EPDS
Page 12
Visit the Premier Mounts website at http://www.mounts.com
Installation Instructions
Selecting the Mounting Hardware
n
n
Insert a small straw or toothpick into the threaded inserts found on the
bottom or top of the projector.
n
o
Use a pencil to mark the depth of the threaded insert on the small straw or
toothpick.
n
p
Mark the straw or toothpick 1/8” above the depth of the threaded insert, as
shown in Figure 1.
n
q
Insert the small straw or toothpick into the remaining threaded inserts to
compare and verify their depth using the straw or toothpick’s 1/8” allowance
mark.
n
r
Locate the correct diameter screw for the threaded insert.
If the screw you selected is longer than the 1/8” allowance mark on the
small straw or toothpick, as shown in Figure 2 and Figure 3, do not use
this screw. The screw length must not bypass the mark.
n
s
Test each size of the screws provided.
The correct screws should thread easily into the mounting point and not pull
out when tension is applied.
Does your projector have multiple mount points or a single mount point?
If your projector has multiple mount points, proceed to the
“Multiple
Mount Point Installation”
section.
If your projector has a single mount point, skip to the
“Single Mount
Point Installation”
section.
Attaching the Universal Projector Plate
Small Straw or Toothpick
Small Straw
or Toothpick
Small Straw
or Toothpick
Marking the 1/8”
Allowance
Depth Plus 1/8”
Allowance
Mark
Depth Plus 1/8”
Allowance
Mark
