PTM / PTM-B
Page 12
Visit the Premier Mounts website at http://www.mounts.com
Installation
Instructions
Securing the Mount
Adjusting the Mount Tension
Use the M3 Allen wrench to tighten the M6 x 35mm set
screw located in the bottom of the PTM mount. The M6
x 35mm set screw prevents your
fl
at panel from being
accidently dislodged.
Do not overtighten the set screw.
Proceed to the
“Adjusting the Mount Tension”
section.
Use the M3 Allen wrench to loosen the M6 x 35mm set screw at the bottom
of the PTM mount.
Gently lift, then gently pull the PTM mount away from the wall until it
disengages from the wall plate.
Set the
fl
at panel face-down on a soft,
fl
at surface.
Remove the two (2) M4 x 5mm Phillips screws from the bottom mounting
points.
Loosen the two (2) M4 x 5mm Phillips screws from the top mounting points.
Do not completely remove these screws.
Gently slide the PTM mount towards the bottom of the
fl
at panel and pull
towards you until the
fl
at panel disengages from the keyhole slots.
Use a socket wrench and the supplied 14mm socket to loosen or tighten
the tension nut.
•
Turn the tension nut clockwise to increase tension.
•
Turn the tension nut counter- clockwise to decrease tension.
Do not overtighten the tension nut.
Tension Nut
Set Screw
M3 Allen Wrench
Replace PTM mount by guiding the heads of the top two (2) M4 x 5mm Phillips screws through the keyhole slots.
Insert two (2) M4 x 5mm Phillips screws into the bottom mounting points.
Tighten all M4 x 5mm Phillips screws.
Do not overtighten the M4 x 5mm Phillips screws.
Lift your PTM mount up to the wall plate.
Slide the top of the PTM mount on to the top of the wall bracket.
Pivot the bottom of the PTM mount towards the wall plate until it rests against the wall.
Do not release the PTM mount until you are certain that it is resting securely on the wall plate.
Use the M3 Allen wrench to tighten the M6 x 35mm set screw located in the bottom of the PTM mount.
Do not overtighten the set screw.
Removing the Mount
Adjusting the Tension
Replacing the Mount
