- 5 -
Step 1
NOTE: Refer to the PSM or CTM series installation instructions to secure the mounting bracket to the plasma display.
Set the PSD-VHSA on the floor and loosely install the PP-SPA adapter over the tubes flat side facing out, attach the two (2) M8 x 10 socket head screws to the
adapter and slowly drop it to all the way until it touches the base. See figure 1.
WARNING
:
Proper installation procedure by qualified personnel as outlined in the installation instructions must be adhered to. Failure to do so could
result in serious personal injury and possible damage to the plasma display.
Step 2
Choose the proper location for the PSD-VHSA and make sure that the location is weight suitable (see warnings). Using (commercially available) suitable hardware
depending on you installation environment the two holes found on the base may be used if needed to fasten the stand to the surface. See figure 2.
(2) M8 x 10 hex
head screws
PP-SPA
Adapter
Suitable hardware
(commercially available)
Getting the plasma ready
Allen wrench
Base
Suitable surface
(see warning)
Base
PP-SPA
Adapter
