PP-FCTA-QL
1) Separate the escutcheon ring and the hole saw.
2) Attach the hole saw to a hand held drill. If no drill is
available, you may turn by hand.
3) Determine where the hole will be and mark this
location with a pencil
(A)
.
4) Place the hole saw over the spot where the mark was
made
(B)
.
5) Carefully depress the trigger on the hand held
drill and begin to drill the hole, being careful not to
damage the ceiling tile
(B)
.
6) Once complete, place the drill off to the side and pick
up the escutcheon ring.
7) Line the escutcheon ring up with the drilled hole in the
ceiling tile
(C)
.
8) Insert the escutcheon ring into the hole and gently
push it into place
(D)
.
(A)
(B)
Ceiling Tile
Drill
Hole Cutter
Mounting Hole
Escutcheon Ring
(C)
(D)
Hand
Escutcheon
Ring
The escutcheon ring has been designed for use with
1-½˝ and 2˝ NPT.
Cutting the Access Hole
Escutcheon Ring
Hole Saw
Observe the room and the ceiling; find the most
appropriate location for the projector placement and
lightly mark the bottom of the tile.
Proceed to the ″Mounting the PP-FCTA-QL″ on
page 6.
You may need to pinch the escutcheon ring into
place. This can be done by taking your index finger
and placing it up into the mounting hole and pressing
down from the top. Your thumb will press up from the
bottom, effectively pinching the escutcheon ring into
place.
Page 5
