MAG
Page - 6 -
Installation Manual
Ceiling Installation
1. Mounting Surfaces
Wood
studs
: Where denoted with the letter ‘
A
’, mark these
locations for wood stud installation.
NOTE:
Use a masonry bit to pre-drill the mounting
holes in the concrete surface.
Concrete
surface
: Where denoted with the letter ‘
B
’, mark
these locations for concrete installation.
2. Use two (2) #14 x 2” wood screws (supplied) to attach the
ceiling plate to the wooden ceiling stud.
NOTE
: For extra security, attach a third wood screw to the
middle mounting point (A).
3. Slowly raise the projector toward the upper assembly. Once
the projector is close to the upper assembly, MagnaGuide™
Technology will pull the lower assembly into the upper
assembly and the locking tab will engage.
WARNING
:
THE MAGNETS ARE USED FOR GUIDING
THE UNIT ONLY! PLEASE MAKE SURE
THE TWO (2) M4 X 12MM SCREWS ARE
USED TO SECURE THE PROJECTOR.
4. Attach the two (2) M4 x 12mm security screws and
star washers that are located on each side of the locking
tab.
NOTE
: Do not release your hold on the projector until the
upper and lower assemblies are engaged and the
locking tab is in place.
NOTE
: If you chose to use the center mounting point for
added security, detach the lower assembly from the
ceiling plate by removing the two (2) M6 x 12mm
security screws, drive the wood screw in place and
reattach the lower assembly and security screws.
Adjusting the Projector
After the projector has been installed, the projector must then be
adjusted. To adjust the projector:
1. Loosen the M5 set screw using the M5 Allen wrench (both
sides).
2. Adjust the projector to the correct position. Firmly grasp the
projector in both hands, and tilt either forward or backward
to adjust the level.
-OR-
Firmly grasp the projector in both hands and rotate side to
side for orientation adjustment.
3. Tighten both M5 set screws using the M5 Allen wrench.
M5 Set Screw
M6 x 12mm
Security Screw
M5 Allen
Wrench
M4 x 12mm Security
Screw and Star Washer