Page 2
LPWS100/LPWS200
Neck Knuckle Assembly
Shelf Installation
Step 1.
Align the neck knuckle on the glass
shelf with the slide channel on the
mounting
column.
Step 2
.
Once aligned, slide the glass shelf
down (doing so while holding the
glass shelf at a 45° angle).
Step 3.
When the desired height setting has
been achieved, slowly let the glass
shelf rest forward to a level position
and “click” into place.
Step 4.
Use an M3 Allen wrench (supplied)
to tighten the locking screw. Do not
over-tighten this screw.
Locking Screw
Slide
Channel
Neck
Knuckle
Glass
Shelf
M3 Allen
Wrench
Shelf Installation
Cable Management
Step 1
.
Place the end caps over the upper and
lower ends of the mounting column
and press these end caps fi rmly into
place.
Mounting
Column
End
Cap
Mounting
Points
Shelf Mounting
Bracket
Step 1.
Place the glass shelf on a soft, fl at surface
(refl ective-side down).
Step 2
.
Place the shelf mounting bracket on the
three mounting points (see above).
Threaded Stud
Glass Shelf
Cap Screw
Step 4.
Turn the glass shelf over (refl ective-side
up).
In the center of the mounting point there is a
threaded shaft. In order to attach the glass
shelf cap screw, the threaded shaft must
be inthe exact center position of the
mounting
point.
Glass Shelf
(Refl ective-side up)
Glass Shelf
(Refl ective-side down)
Step 5
.
Slowly turn and tighten the glass shelf
cap screw onto the threaded shaft. Do not
over-tighten the glass shelf cap screw.
Step 1
.
Align the cables on either side of
the mounting column.
Mounting
Column
Cables
Plastic
Tabs
Cables
Shelf Assembly
Step 1.
Place the mounting shelf bracket and the
neck knuckle together and align the
mounting holes to the mounting points.
Step 3
.
Using a screwdriver, insert and tighten
two (2) screws and two (2) fl at washers
(supplied). Do not over-tighten these
screws.
Step 2
.
Insert and tighten two (2) Phillips fl at
head
screws.
Screwdriver
Screw and
Flat Washer
Step 2
. Once the cables have been
aligned, gently tuck the cables
into the mounting column.
The plastic tabs will hold the cables
in place once they have been tucked
completely into the mounting
column.
Shelf Mounting
Bracket
Neck Knuckle
Mounting
Points
Mounting Holes
Screwdriver
Phillips Flat
Head Screw
