LPWS100/LPWS200
Installation
Instructions
Page
1
9533-100-001-00
Step 1.
Determine where the shelf will
be installed on the wall.
Step 2.
Use a stud fi nder to locate the wall stud.
Step 3.
Use a pencil to mark where the
stud is located.
Wood Stud Installation
LPWS100/LPWS200 Shelf Installation Instructions
Installation Tools
(not supplied)
Screwdriver
1/8” Drill Bit
Electronic
Stud Finder
Drill
Level
Hammer
Pencil
1/4” Drill Bit
Mounting Column
Glass Shelf
Wall Anchors
Wood Screws
Flat Head
Screws (Qty 2)
Phillips Head Screw (Qty2)
Flat Washers (Qty 2)
M3 Allen Wrench
Step 4.
Place the mounting column over the
located wall stud.
Step 5
.
Level the mounting column.
Step 6
.
Use a pencil to mark the mounting
locations (two marks for the LPWS100
and four marks for the LPWS200
mounting
locations).
Step 7.
Use a 1/8” drill bit and drill to
pre-drill the mounting holes at the
marked
locations.
Step 8.
Place the mounting column against
the wall and align the mounting points
on the shelf mount with the pre-drilled
mounting
holes.
Step 9.
Insert and tighten the screws and
re-level the mounting column to
verify the position.
Stud Finder
Mounting
Column
Mounting
Location Mark
Drill
Step 6.
Place the mounting column against
the wall and align the mounting points
on the shelf mount with the wall
anchor
holes.
Step 7
.
Level the mounting column.
Step 8.
Insert and tighten the screws and
re-level the mounting column to
verify the position.
Mounting
Column
Mounting
Location Mark
Drill
Step 5.
Once the mounting holes have been
drilled, insert the wall anchors by
gently pressing the wall anchors into
place.
Level
Mounting
Column
Mounting
Location Mark
Step 1.
Determine where the shelf mount will
be installed on the wall.
Step 2.
Place the mounting column fl at
against the wall. Make sure the
mounting column is level.
Step 3.
Use a pencil to mark the holes where
the mounting column will be located.
Solid Surface Installation
Shelf Mounting Bracket
Glass Shelf
Cap Screw (Qty 1)
Column End Caps
(Qty 2)
Inserting Wall
Anchor
Gently Press
into Place
Wall Anchor
LPWS100
LPWS200
LPWS100 -
(Qty 1)
LPWS200 -
(Qty 2)
LPWS100 -
(Qty 1)
LPWS200 -
(Qty 2)
LPWS100 -
(Qty 2)
LPWS200 -
(Qty 4)
LPWS100 -
(Qty 2)
LPWS200 -
(Qty 4)
Level
Mounting
Column
Mounting
Location Mark
Neck Knuckle (Qty 1)
Step 4.
Use a 1/4” drill bit and drill to
pre-drill the mounting holes.
Wall Anchor
