- 7 -
Step 5
Install the mount to the rear of the display with the mounting hardware supplied. Lift the display and mount assembly (minimum two people recommended) and
secure to the base pan by allowing the mount tabs to be inserted fully into and down the receiving slots on the back of the plenum. See figure 5. Decorate the
front of the Plenum per customer request.
Step 4
Install the ventilation assist fan (if used) on one of the three 10/32” thread mounting points in the top of the base pan with the three 10/32” nuts supplied.
The fan supplied uses 110-volts A/C current and comes with “pig tail” ends. It is recommended the fan be wired to the same 110-volt A/C switch leg as the
feeding power to the display. This will insure the operation during all times when the display is on. Install all power and signal interface cables. See figure 4.
Plenum
Muffin fan
(3) 10/32” Hex
nuts
Figure 4
Figure 5
Wall structure
Receiving tabs
on the plenum
Mounting
bracket
Plenum
Caution: All four (4) tabs
must be fully inserted to
the receiving tabs before
letting go of the display.
Muffin fan
bracket
studs
Display
