AM225
AM225
Page 10
Visit the Premier Mounts website at http://www.premiermounts.com
Installation Instructions
Installation Instructions
Visit the Premier Mounts website at http://www.premiermounts.com
Page 11
Installing the Pullout Mount
M8 x 12mm combo Phillips
screw
M5 x 8mm combo Phillips
screw
Fig. 1
Fig. 3
Attach a P-Series Mount and/or Accessories
AM225 with P4263T tilt
mount
Use four (4) M8 x 16mm pan Phillips screws to attach
the P-Series P4263F or P4263T flat-panel mount to the
AM225.
Follow the installation instructions included with the
P-Series mount.
Make sure the P-Series mount is aligned to the
center of the pullout portion of the AM225.
Proceed to the “Post-Installation Adjustments”
section.
Post-Installation Adjustments
➊
Remove the M5 top-side screws on location “
A
” to
swivel.
You cannot re-insert the top-side screws unless the
mounting plate is centered.
Do not remove the M8 middle screw.
➋
Use an M2.5 Allen wrench to loosen the screws on
locations “
B
” to adjust the pullout tension.
Stop loosening when the desired tension is
achieved.
Proceed to the “Cable Routing” section.
Back view of the AM225
pullout mount
A
B
AM225 with P4263F flat
mount
M8 x 12mm combo Phillips
screw
Pullout Mount
Wall Frame
➊
Pre-install two (2) M8 x 12mm combo Phillips
screws in the top screw holes of the wall frame
(Fig.1) using at least 5 full turns.
Leave a gap between the heads of the screws and
the wall frame for hanging the pullout mount.
➋
Hang the pullout mount on the M8 x 12mm combo
screws that were pre-installed in the wall frame
(Fig. 2).
The keyhole design
of the pullout mount’s
screw holes makes hanging easier.
➌
Use (2) M8 x 12mm combo Phillips screws to attach
the bottom of the pullout mount to the wall frame
(Fig. 3).
➍
Use two (2) M5 x 8mm combo Phillips screws to
attach the middle of the pullout mount to the wall
frame (Fig. 3).
➎
Tighten the top M8 x 12mm combo Phillips screws.
Proceed to the “Attach a P-Series Mount and/or
Accessories” section.
Fig. 2
