Rubber Plug (pre-installed)
Active carbon filter
Remote control
Round cap for filling the hole in wall/window.
Outdoor adaptor - for insertion over hose and into hole in
the wall/window.
Fishtail adaptor -
Open door to an appropriate angle to fit
adaptor to outside.
F. INSTALLATION
This unit is a portable air conditioner, which can be moved from room to room.
Using the adaptor
Cut a 130mm diameter hole in the
wall or window, using the
appropriate tools and safety
equipment.
Feed exhaust hose through the
window or wall and attach the
outdoor adaptor from the outside
as shown.
When not in use, cover the hole
with the cap provided.
Installing the exhaust hose
Use only the hose provided and clip exhaust hose and unit adaptor to the
back of the air conditioner.
Avoid kinks and bends in the
exhaust hose as this will cause
expelled moist air to build up
causing the unit to overheat and
shut down.
The hose may be extended from
300mm to 1500mm, but for
maximum efficiency use the
shortest length possible.
WARNING!
Do not replace or extend the hose as this could cause the unit to malfunction.
Installing the carbon filter
1. Remove the filter frame from the
unit.
2. Remove the active carbon filter
from its plastic bag.
3.
Insert the active carbon filter into
the back of the unit.
4.
Re-fit the filter frame inside the
unit.