IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user of the
product for future reference.
INSTALLATION
For free-standing use:
attach the feet to the underneath of the heater using
the four 12mm (½") screws. The feet fit over the pre drilled holes in the
case approximately 95mm from the end of each side.
To wall-mount:
Referring to the diagrams below, draw two horizontal lines
on the wall 330mm apart, the lower line more than 50mm from the floor.
On the upper line, drill holes 310mm apart, using a 6mm (¼") masonry bit,
and insert a wall plug in each hole.
On the lower line, drill holes 435mm apart centred directly below the upper
holes using a 6mm (¼") masonry bit, and insert a wall-plug. See Fig 2.
Insert the 30mm screws into the upper holes and tighten to within 8mm of
the wall. See Fig 2.
wall plug
wall plug
Fig 1
Fig 2
Fig 2.
