Prem-I-Air EH1461 Manual Download Page 7

Appliance stops operating and 

P1

 

is displayed. 

 This happens if the temperature is lower than 10 °C, and ice begins to

form on the internal heat exchanger. The defrost cycle will last for a few
minutes, and then operation will resume.
Appliance operates intermittently.

 The humidity in the room has reached the level set on the humidistat

control.
Very little water is extracted.

 There is very little humidity in the air (this happens during dry sunny

weather, and also during very cold weather). Condensation on windows is
caused by the difference between indoor and outdoor temperatures, and
is not a good indicator of the level of humidity.
The room remains humid and little water is extracted

 The humidity setting is too high, press the − button to reduce the

required humidity level.

 The area to be dehumidified is too large

FAULT CODES

F1 

Humidity sensor fault. 

F2

 Temperature sensor fault.

If either of these faults is detected, stop the appliance by pressing the
power button. When it has stopped, switch off at the mains socket and
wait 3 minutes. Switch back on, and restart the appliance. If the fault
repeats contact your dealer.

P1

 Appliance is defrosting: This happens if the temperature is lower than

10 °C, and ice begins to form on the internal heat exchanger. The defrost
cycle will last for a few minutes, and then operation will resume.

P2

 Bucket fault. Either the bucket is full, or it is misaligned. Empty the

bucket and make sure it is correctly positioned in the appliance.

OPERATING COSTS

At time of going to press, the average cost of electricity is £0.12 per unit
(kilowatt-hour). The amount you are being charged will be shown on your
electricity bill.
At this cost, the appliance will cost £0.07 per hour to run on the
"continuous" setting. If the humidistat is used, the operating costs will be
lower.

 Page 7

Summary of Contents for EH1461









Reviews: