Page 6
If the mains lead is damaged, it must be replaced by the manufacturer or an
authorised service centre. If the mains plug needs to be replaced, proceed as
follows:
Connect the brown wire to the
terminal labelled "L".
Connect the blue wire to the
terminal labelled "N".
Connect the green/yellow wire to
the terminal labelled with the earth
symbol or "E".
Make sure that the cord-grip is
positioned correctly (over the
outer sheath of the cable) and it
fully tightened.
If the plug is fitted with a 13 A fuse, replace it by a 5 A fuse.
FAULT FINDING
Appliance stops operating and "FULL" indicator lights.
• Bucket is full of water - empty the water as shown on page 6. Do not drink the
water (it may be used for watering plants).
• Bucket is not replaced properly. Ensure that the bucket is correctly aligned with
the housing.
Very little water is extracted.
• There is very little humidity in the air (this happens during dry sunny weather,
and also during very cold weather). Condensation on windows is caused by the
difference between indoor and outdoor temperatures, and is not a good indicator
of the level of humidity.
The room remains humid and little water is extracted
• The area to be dehumidified is too large
OPERATING COSTS
At time of going to press, the average cost of electricity is £0.12 per unit (kilowatt-
hour). The amount you are being charged will be shown on your electricity bill.
At this cost, the appliance will cost £0.08 per hour to run on the "continuous"
setting. If the humidity control is used, the operating costs will be lower.
