Page 3
PAT TESTING
When used in an office environment, this product must be safety-tested yearly by
a qualified electrician (PAT Tested) in order to comply with the Electricity at Work
Regulations.
We recommend that it is PAT tested regularly when used in a domestic
environment.
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a qualified electrician at least once
every 10 years or at every change of occupancy.
For office and retail premises, and buildings such as village halls, the wiring must
be inspected at least once every 5 years.
It is recommended that all building be fitted with smoke alarms (it is mandatory for
new buildings).
OPERATING COSTS
At time of going to press, the average cost of electricity is 12p per unit (kilowatt-
hour). The amount you are being charged will be shown on your electricity bill. At
this cost, the fan will cost 5p per hour to run on the "low speed" setting, or 5½p per
hour to run on the "high speed" setting.
MAINTENANCE
Before cleaning, turn the appliance off, and disconnect from the mains
supply. The appliance may then be cleaned using a damp cloth with a drop
of washing-up liquid to remove any dust or dirt from the case. Do no use
stronger detergents or solvents as these may damage the paint finish.
Using a dry 1" (25mm) paint-brush, remove any dust from the grilles.
If the mains lead is damaged, it must be replaced by the
manufacturer or an authorised service centre.
If the mains plug needs to be replaced,
proceed as follows:
Connect the brown wire to the
terminal labelled "L".
Connect the blue wire to the
terminal labelled "N".
Connect the green/yellow wire to
the terminal labelled with the earth symbol or
"E".
Make sure that the cord-grip is positioned correctly (over the outer
sheath of the cable) and it fully tightened.
5A
