Pregis AirSpeed MINI PAK'R, User Manual

Page: 10 / 157

MINI PAK’R 제조기 사용자 설명서 -16- 페이지
Korean/한국어
MINI PAK’R Machine User Manual Page - 17 -
ENGLISH
Table of
Contents
MINI PAK’R Machine User Manual Page - 16 -
ENGLISH
Table of
Contents
3
Push spring-loaded
rollers toward front of
Machine to loosen either
Seal Belt. Remove Seal
Belt and replace it.
Replace both Seal Belts.
Replace the Seal Belts when:
• The film jams frequently.
• The film does not advance with drive motor running.
• The machine is producing very poor seals even after
adjustment of the seal temperature.
1
Turn Power OFF, unplug Power
Cord, then wait 10 minutes for Seal
Bar to cool. Open Belt Cover with
Slotted or Phillips Screwdriver.
2
Lift Belt Release
Lever to loosen
Seal Belts.
Tighten Seal Belts by
locking Belt Release
Lever in place.
4
Replacing Seal Belts
Weekly Maintenance: If necessary, clean the Seal Belts and the Drive Rollers. Warm water and mild detergent are recommended.
Monthly Maintenance: Check the entire MINI PAK’R Machine for damage. Replace worn or damaged parts, if necessary, and/or
contact your distributor.
Routine Maintenance
Display
Code
Error Action
E1
Cover Open Make sure covers are closed.
E2 Jam/end of roll In case of jam, open Belt Cover and remove jammed film carefully.
E3 Temp. too high Contact your distributor or Pregis for assistance.
E4
Temp. too low Contact your distributor or Pregis for assistance.
E5
Temp not rising Contact your distributor or Pregis for assistance.
E6
No roll detected Press STOP/RESET. This may clear the error. If not, Display will show “Sty” (Standby
state). Advance the film slowly at the front of the Machine so the Film Roll rotates. The
display should change to show the seal temperature, and then “rdy” (Ready state). If
the error can’t be cleared, contact your distributor or Pregis for assistance.
E8 Thermocouple Error TC is broken or not connected.
E9
Invalid Tag Error RFID Tag for a different machine is detected.
E10
Temperature Measurement
Error
Initialization Error. Press reset and repower the machine.
E11 Temperature Timeout Temperature reading initialization timed out.
If the Display shows an Error Code, and the red LED flashes, consult the chart below to
determine the cause. Clear the problem as described below then press the STOP/RESET
Button to resume normal operation.
Error Codes
Display
Error Codes