3.6.3
Gradual setting page
After entering the Gradual Setting page (refer to Figure 3.14), first, select the testing
mode to be programed, the
Voltage Gradual testing
(press the icon
) or
the
Current Gradual testing
(press the icon
). Then, program the
following parameters: output
voltage
/
current
and
dwell time
for each Gradual Set at
the left area;
start number
and
end number
of Gradual Set and
cycle times
at the
right area. After finishing the setting above, press the icon
to enter into
the Gradual Performing page.
(a)
Gradual Step setting
(b)
Gradual Step setting
Figure 3.14 Gradual setting page
The descriptions for the items and the icons in the above figure are given as follows.
Displays the number of Gradual Set (up to 12 sets)
Sets the start and end output voltage of Gradual Set in volts
Sets the start and end output current of Gradual Set in amps
Sets the dwell time of Gradual Set (Hour/Minute/Second)
Scrolls up the list of Gradual Set
Scrolls down the list of Gradual Set
Sets the start number of Gradual Set
Sets the end number of Gradual Set
Sets the cycle time of testing (zero for infinite loop)