Precor TRM 800, Assembling And Maintaining Manual

Page: 57 / 68

Maintenance
55
Monthly Maintenance
Perform the following maintenance tasks every month:
1.
Check the alignment of the running belt as described in
Checking the Alignment of the Running Belt . If the belt
requires adjustment, see Adjusting the Running Belt .
2. Turn off the power switch or circuit breaker, then unplug
the unit from the wall outlet.
3. Inspect the running belt and running deck for wear.
4. Clean the running belt and running deck as described in
Cleaning the Running Belt and Deck.
Note: Precor recommends that you clean the running belt
weekly to improve the longevity of the belt.
5. Clean the treadmill’s frame using a cloth moistened with
water or an approved cleaner.
6. Use water and a soft nylon scrub brush to clean the outer
surface of the running belt.
7. Wipe the exterior of the console with a damp sponge or
soft cloth, and dry with a clean towel. Keep water away
from electronic components to prevent electrical shock or
damage.
8. Clean the touchscreen using a soft, lint-free cloth
dampened with a 91% isopropyl alcohol solution (either
as sold or diluted with an equal amount of water).
9. Remove the front cover and remove any lint or debris,
being careful not to damage the fan.
10. Vacuum out any debris, being careful not to bring the
vacuum cleaner nozzle too close to any circuit board
(unless your vacuum cleaner is protected against static
buildup).
11. Clean and lubricate the lift motor screw with an approved
grease such as SuperLube® with Teflon® or Mobil 1®
synthetic grease.
12. Check all fasteners for proper tightness and torque.
13. Replace all covers.
14. Verify that the unit sits squarely on the floor. All of its feet
should be touching the floor and the unit should not rock
or wobble when in use. If not, re-level it as described in
Leveling the Unit.