Precor TRM 800, Assembling And Maintaining Manual

Page: 50 / 68

48
Assembling and Maintaining TRM 800-Series Treadmills
Plugging In the Power Cord
CAUTION: Use the supplied power cord. Do not remove or
otherwise bypass the 3-prong plug with an adapter to use a
non-grounded outlet. Do not plug the unit into a power
transformer in an attempt to adjust the voltage requirements.
Failure to follow these instructions might damage the unit and
void the Precor Limited Warranty.
After assembly is complete, plug the power cord into an
appropriate outlet.
Important: The treadmill requires a 20-amp individual branch
circuit grounded per NEC (National Electric Code) guidelines or
local region electric code.
Checking Treadmill Alignment and
Adjusting the Running Belt
Before you allow anyone to use the treadmill, you must check
the alignment of the running belt and adjust it as needed. For
more information, refer to Checking the Alignment of the
Running Belt and Adjusting the Running Belt in the Maintenance
chapter.
Breaking In the Equipment
Precor equipment does not require an actual break-in period.
However, moving components such as belts, gears, and
bearings can settle while the equipment is being stored or
shipped. This can cause the equipment to operate with a
small amount of roughness or noise when it starts up for the
first time.
The equipment usually returns to smooth operation after a
day or two of normal use. If it does not, contact your dealer
for assistance. For more information, refer to Obtaining
Service .