Precor P20 Console, Operating And Maintenance Instruction Manual

Page: 21 / 112

Setting Up the Console
19
Event Log
The software is able to detect a variety of events. The event
log holds a maximum of 30 events. After the log reaches 30
events, older events are erased to make room for newer ones.
Note: There is a shortcut for quick access to the Event Log
report. From the Welcome banner, press Reset ( Pause/Reset
on tread consoles) for five seconds. If there are no events, the
words STUCK KEY appear and then the console returns to
the Welcome banner.
Each event log entry contains the following information:
 Event number

Odometer value when the event occurred

Hour meter value at the time the event occurred

Current drawn by the motor when the event occurred
(treadmill only)
The following table contains a list of events detectable by the
software.
Table 2. Event log numbers and descriptions
Event
Number
Description of Event
00 Upper PCA memory location event
02 RAM location event
03 EEPROM checksum event
05 Depressed key at power up
09 Lower PCA memory test event
10 Line Frequency out of acceptable range
11 Watchdog (Upper PCA) low voltage power
12 Watchdog (Lower PCA) low voltage power
13 Fan at incorrect speed (version 1 treadmills)
14 Fan fail (Lower PCA)
15 AC input voltage too high
16 AC input voltage too low
20 Too many maximum power requests in one second
21 Too many maximum consecutive power requests