Precor Experience 800, Assembly Manual

Page: 12 / 80

Check the alignment of the running belt
1. Turn on the treadmill.
2. Standing beside the treadmill (not on it), press
GO or QuickStart on the console.
3. Press SPEED UP until the console shows a speed of 3 MPH (5 KPH).
4. Observe the belt from the rear of the treadmill for a few minutes. The belt should
remain centered along the running bed. If it drifts off center, adjust it (refer to
Adjust the running belt tracking section).
Important Failure to align the belt may cause the belt to tear or fray, which is not
covered by the Precor Limited Warranty.
5. Press STOP to stop the belt.
6. Turn off the treadmill.
Safety code
All Precor treadmills contain an inactive safety code feature that requires activation
to prevent unauthorized use. If you wish to activate this safety code, read it online in
the Assembling and Maintaining TRM 800-Series Treadmills Guide at www.precor.com .
Test safety features
Important Before any exerciser uses the treadmill, verify that the STOP button, reset
switch, and Auto Stop™ feature are all working correctly.
To test the Stop button:
1. Start any workout on the treadmill.
2. Press
STOP once. The console indicates that the workout is paused.
3. Press STOP again. The console displays a workout summary.
To test the reset switch:
1. Start any workout on the treadmill.
2. Give the safety clip lanyard a slight tug. The reset switch pops up and the
treadmill should slow to a stop immediately.
3. Press the reset switch back into its normal position. The console should reset
itself and return to the Welcome screen or banner.
Treadmill Auto Stop™
Important The default setting for this feature is ON. An administrator can turn off this
feature in the System Settings; however, Precor recommends it remain ON.
Auto Stop™ (Automatic Stop) is a feature designed to bring the treadmill to a gradual
stop when it is not in use (after two minutes). This might occur if an exerciser steps
off the treadmill before the end of a workout and leaves the treadmill running.
To test Auto Stop\ ™ :
1. Start any workout on the treadmill, but DO NOT step onto the running belt.
2. Wait two minutes without stepping onto the running belt. At this point or shortly
beforehand, the treadmill should slow to a stop and the console should ask the
previous user to confirm that he or she is still present. If there is no confirmation,
the console returns to the Welcome screen or banner and it is safe to step onto
the running belt.
uation 1: Français
800 Line TRM Assembly Guide | P/N 305032-101, rev A, ENU
©2016 Precor Incorporated | September 2016
10