Diverging Lat Pulldown Assembly Guide: Routing the Cable Assembly
10
Routing the Cable on the Weight Tower
The weight tower ships with the kick cover and pulley cover attached.
To route the cable on the weight tower:
1.
Using a
⁵₃₂
-inch hex bit, remove the screw and pulley cover and set them
aside.
Figure 13: Kick plate pulley cover removal
2.
Grasp the kick cover on either side (see arrows in the following figure) and
press inward slightly so that the notches on the back of the kick cover
unlock from their mounts.
Figure 14: Kick cover removal
3.
Gently lift the kick cover and set it aside.
Summary of Contents for Discovery DSL0314
