Precor CW-702, Assembly Manual

Page: 36 / 44

General Safety and Maintenance Manual: Monthly Inspection 22
To remove surface rust from the frame, rub lightly with a fine wet/dry
sand paper or fine steel wool. Finish with Precor’s touch-up paint if
needed. Maintain paint luster with an application of a mild automotive
wax product.
To maintain the powder coated and chrome parts, use a mild
detergent-based cleaner for light dirt and grime removal. For removing
heavier dirt and grease and for polishing, use a good automotive
polish. For scuffs and marks that are not removed by the above
methods, use a fine-grit cleanser. Do not use solvents, lacquer thinner,
acetone, or finger nail polish remover. For high wear areas, ABS
shields have been provided. Replacement shields are available from
Precor Customer Support. For additional information refer to
Obtaining Service .
Lubricate Pop Pins
Pull out the pop pin as far as it goes and apply a small amount of
silicone spray lubricant. Wipe off any excess lubricant with a cloth.
(Refer to Figure 11.)
CAUTION: Pulling out the pop pin may cause the unit to adjust
position suddenly. To avoid injury, keep your hands and head
away from moving parts.
Test the pop pin for proper function and engagement in each
adjustment hole.
Figure 11: Lubricate the pop pin by pulling it out