Rev 8/2014
PrecisionTemp, Inc • 11 Sunnybrook Drive • Cincinnati, Ohio, 45237 • 1-800-934-9690 •
fax 513-641-0733 50
SB-10 Changing Outlet Temperature Setting
Model:
PT-200FT, PT-200RC & PT-56
Software version:
All
Tools Required:
Small flat blade screw driver
Digital Multi meter/Voltmeter
Process:
NOTE:
The temperature on the booster heater has been factory set to
approximately 192°F. It is not recommended that you change this setting. Doing
so could result in water temperature too low to sanitize dishware or high enough
to bake food matter onto dishes, or cause booster heater to overheat water and
shut down. If it is necessary to change the setting it can be done as follows:
1. Open access door of heater. Open the electronic drawer. The adjustment
screw is located on a small blue block at the lower right corner of the
electronics board (see reference illustration #200-14).
2. Use a voltmeter and insert the black lead in black test point and the red
lead in blue test point (see reference illustration #200-14). A reading of
4.20 VDC from the voltmeter will set the temperature control at 192°F. A
small blade screwdriver should be used to adjust the temperature screw.
To decrease temperature, turn screw counterclockwise. To increase
temperature, turn screw clockwise. Each full turn will change the water
temperature approximately 7°F.
3. Check the water temperature on digital display of booster heater or at
temperature gauge on dish machine and adjust as necessary.
Kit Parts List:
None
Reference Illustrations:
200-14
Electronic Control Board
