2
MOUNTING THE UNIVERSAL BRACKET and STEERING POSITION SENSOR
Attach the universal mounting bracket on the right side of the machine using the provided 1/2” hex-
head bolts. Drill holes to fit the mounting bracket pattern and the air filter support hole pattern in a
steel plate. Figure 1 shows the bracket mounted to the machine with the valve attached and the
steering position sensor band-clamped to the right steering cylinder and the steering control arm.
FIGURE 1
MOUNTING THE HYDRAULIC VALVE and PRESSURE SWITCH
Position the hydraulic valve on the universal bracket over the top of the proper hole pattern. Secure
the valve to the bracket using the provided metric bolts and lock washers. Note: It may be neces-
sary to drill additional holes in the mounting bracket if the valve is not in an accessible posi-
tion.
Remove the elbow fitting from the pressure switch and attach the switch to the PS-port on the valve by
turning the solenoid connection so the switch just fits on the valve. Secure the switch by tightening
the remaining swivel fitting on the valve. (Shown in Figure 2)
Control valve is mounted
to a steel plate that must
be made to fit 3 existing
holes on the machine’s air
filter support bracket.
Steering Position Sensor mounted to
right side steering cylinder and the
control arm of the wheel. Cables for
the sensor are run along the axle
with enough extra cable to
accomadate for different axle widths.
Elbow fittings route
the hoses upward.
Pressure switch
and solenoid
connections may
need to be turned
to fit on the valve
as shown.
FIGURE 2
