Precision matthews PM-940V-PDF, Owner'S Manual

Page: 3 / 23

11.WEAR PROPER APPAREL. No loose clothing,gloves,neckties,rings,
bracelets,or other jewelry to get caught in moving parts. Nonslip foot wear
is recommended. Wear protective hair covering to contain long hair.
12.ALWAYS WEAR EYE PROTECTION.
Refer to ANSIZ87.1 Standard for
appropriate recommendations. Also use face or dust mask if cutting
operation is dusty.
13.SECURE WORK. Use clamps or a vise to hold work when practical.
It's safer than using your hand and frees both hands to operate tool.
14.DON'T OVERREACH. Keep proper footing and balance at all times.
15.MAINTAIN TOOLS IN TOP CONDITION.
Keep tools sharp and clean for best and safest performance.
Follow
instructions for lubricating and changing accessories.
16.DISCONNECT TOOLS before servicing and when changing accessories
such as blades,bits,cutters,ect.
17.USE RECOMMENDED ACCESSORIES.
Consult the owner's manual for recommended accessories .The use of
improper accessories may cause hazards.
18.AVOID ACCIDENTAL STARTING. Make sure switch is in "OFF" position
before plugging in power cord.
19.NEVER STAND ON TOOL.
Serious injury could occur if the tool is tipped
or if the cutting tool is accidentally contacted
20.CHECK DAMAGED PARTS.
Before further use of the tool, a guard or
other part that is damaged should be carefully checked to ensure that it will
operate properly and perform its intended function check for alignment of
moving parts binding of moving parts, breakage of parts mounting, and any
other conditions that may affect its operation. A guard or other part that is
damaged should be properly repaired or replaced.
21.DIRECTION OF FEED.
Feed work into a blade or cutter against the
direction of rotation of the blade or cutter only.
22.NEVER LEAVE TOOL RUNNING UNATTENDED.TURN POWER OFF.
Don't leave tool until it comes to a complete stop.
23.DRUGS,ALCOHOL ,MEDICATION. Do not operate tool while under the
influence of drug, alcohol or any medication.
24.MAKE SURE TOOL IS DISCONNECTED FROM POWER SUPPLY while
motor is being mounted, connected or reconnected.