2
2.
See the figure below. The add-on radiation loop is connected in series with the existing radiation loop.
Connect one end of the existing radiation loop to the
left input
(looking at the front) on the tuner case.
Connect the other end to the six-inch SO239 extensions. Secure it with the supplied Adel clamp to the
back of the tuner case using the existing bolt.
Connect the two “L” SO239 connectors back
-to-back to
form an offset. Connect one end of the add-
on loop to the output of the two “L” connectors. Connect
the other end to the
right input
(looking at the front) of the tuner case.
Figure 3 Routing the radiator
3.
The radiation loop is made up of two turns. The loops are separated by two spacers. These spacers are
placed at approximately the 90-degree and 270-degree positions on the loop. Use the supplied zip ties
and affix them as shown below.
Figure 4 Radiator loop spacers