Faults
53
Faults
WARNING
Operating a damaged or faulted tacker can
cause severe or fatal injury.
Disconnect the tacker from the
compressed air supply in case of fault (see
page
Fehler! Textmarke nicht definiert.
).
Empty the magazine (see page
Fehler!
Textmarke nicht definiert.
).
Do not use the tacker until the fault has
been corrected.
ATTENTION
The tacker can be damaged by repairs performed by
unauthorized persons.
Make sure that repairs to the tacker are performed only by
the manufacturer.
Removing jammed fasteners
4C-WZ38BNH /
4C-WZ38BNH400
The tacker has a removable cover plate at the tip of the tool. This can
be used to remove jammed or deformed fasteners from the tip of the
tool.
To remove a jammed fastener, proceed as follows:
Disconnect the tacker from the compressed air supply (see page
Fehler! Textmarke nicht definiert.
).
Empty the magazine (see page
Fehler! Textmarke nicht
definiert.
).
Unlock the clamp closure (1) and lift up the cover plate (2).
Summary of Contents for 1A-AZ16BNH
Page 28: ...Eintreibger t bedienen 4C WZ38BNH 4C WZ38BNH400 28...
Page 47: ...Nach dem Betrieb 47 Schlie en Sie das Magazin siehe Seite 29...
Page 117: ...After operation 47 Close the magazine see page 28...
Page 137: ...Technical data 67 Noise characteristics per DIN 12549 1999 LWA 1s 95 3 dB LpA 1s 82 3 dB...
