MRE+ series Receivers
ENGLISH
EN_02_19
2
8.
SELECTION OF RELAY OUTPUT OPERATING MODE
Power up the receiver.
Select the relay you wish to set pressing
“SET” button repeatedly: each led corresponds to a relay.
Press button
“SET” : the selected relay led begins to flash corresponding to its switching mode:
3 flash : Timed mode
2 flash : Bistable mode
1 flash : Monostable (~1.5s)
To change the selected relay switching mode :
Turn the trimmer wheel according to the arrow printed on the board: left end stroke select monostable function, right end stroke
bistable output. Midway positions to select timed output as shown in figure below.
Press “ENTER” button to save new setting into the selected relay.
To set other relays press
“SET”.
To exit programming mode, select the last relay and again press button
“SET”: the relay leds turn off.
The exit comes about 10 seconds automatically after the last operation.
9.
PASSWORD PROTECTION
On board memory can be protected with a numeric password via PC link and WinAccess software.
Password must be a number in the range from 1 to 65534.
If Password is from 1 to 32767 only programming / deletion
of user data through “ENTER RADIO” button is disabled.
If Password is from 32768 to 65535 either programming / deletion of user data and programming
of relays through “SET” button are disabled.
10. LAYOUT OF TERMINALS AND LEDS
DECLARATION OF CONFORMITY
Prastel declares that the following radio electric equipment type: receiver
MR2E+/MR4E+
complies with Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet address: www.prastel.com
Terminal n°
Designation
1 - 3
Power supply
– 12/24V AC/DC
2
Antenna
4
Antenna shield
5 - 7
Contact NO relay 1
6 - 8
Contact NO relay 2
9 - 11
Contact NO relay 3 (MR4E+ only)
10 - 12
Contact NO relay 4 (MR4E+ only)
GT+ programming plug
Trimmer position (from left to right) and corresponding relay switching time
1/2
0
4/4
1/4
(0.5s)
3/4
(140s)
(15s)
Bistable
Monostable (default)
Relays Leds
Power Led
Radio Led
BP ENTER RADIO
BP SET
Trimmer
Not in use
