MPSPTP2E
REPLACEMENT OF THE BATTERIES
Loosen screw A (fig. 3) and open the remote control.
Fit new battery taking care of aligning polarity correctly (fig. 4).
During the operation, handle the battery as shown in fig. 5.
FCC ID: ON3TP2E
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
A
Via del Vetraio, 7 40138 Bologna – ITALIA
Tel. +39 051 6023 311 Fax: +39 051 538 460
http://www.prastel.com e-mail:
Fig. 5
Fig. 3
Fig. 1
Fig. 4
Fig. 2
