background image

 

 

SECTION 1   

 

GENERAL INFORMATION 

 
This manual is provided for you so that your 
pressure washer may be properly, safely and 
effectively applied and operated. Please read and 
understand all aspects of this manual before 
operating your pressure washer. Please also read 
and understand the documentation supplied with 
this pressure washer regarding the engine and 
pump.  Keep this documentation in a safe and 
accessible place so that reference can be made as 
needed. All operators, users and subsequent 
owners of this pressure washer must read and 
understand all aspects of this documentation before 
operation. 

Please make note that your pressure 

washer is equipped with a thermal relief valve. If 
water begins to spray from your pump during 
operation it is likely because water temperature 
has exceeded 140°F.

 This usually occurs if the 

machine is left running during periods(usually 5 
minutes or more) of non-use. This is a safeguard 
against damage which can occur with high water 
temperatures. It is recommended that the engine be 
shut down if the pressure washer will not be used 
for extended periods. 
 

SPARK ARRESTING MUFFLER 

Certain  States and Jurisdictions require that engine 
driven equipment be fitted with spark arresting mufflers. 
Depending on the model, spark arresting mufflers may 
or may not be fitted. If spark arresting mufflers are 
required for your specific location and the pressure 
washer muffler is not spark arresting, contact your local 
dealer for instructions for a retrofit. 

 

EXHAUST EMISSION CONTROL SYSTEM 

The exhaust emission control system for this pressure 
washer complies to the standards set forth by the 
California Air Resources Board (CARB) and the 
Environmental Protection Agency (EPA). Warranties for 
the exhaust emission system are administered by the 
respective engine manufacturers. Refer to the engine 
documentation for warranty information. 

 

WARNING 

The engine exhaust from this product contains 
chemicals known to the State of California to cause 
cancer, birth defects, or other reproductive harm. 

 

THIS SYMBOL IS USED THROUGHOUT YOUR 
OWNER

S MANUAL TO BRING ATTENTION TO 

IMPORTANT SAFETY INSTRUCTIONS. FAILURE TO 

READ, UNDERSTAND AND FOLLOW SAFETY 
INSTRUCTIONS COULD ENDANGER YOU OR OTHERS AND 
RESULT IN PERSONAL INJURY OR DEATH. 

 

DO NOT OPERATE THIS PRESSURE WASHER 
WITHIN AN ENCLOSED AREA. THE EXHAUST 

GASES OF THIS PRESSURE WASHER EMIT 

DEADLY

 

CARBON MONOXIDE. EXPOSURE TO CARBON MONOXIDE 
CAN CAUSE CARBON MONOXIDE POISONING, 
HEADACHES, NAUSEA, SEVERE SICKNESS OR DEATH. 

 

DANGER: PARTS OF THIS PRESSURE WASHER 
SUCH AS THE ENGINE, MUFFLER, AND PUMP CAN 
BECOME VERY HOT DURING OPERATION. 

CONTACT WITH THESE PARTS CAN CAUSE SERIOUS 
INJURY. ALWAYS ALLOW ADEQUATE COOL DOWN TIME 
BEFORE SERVICING. 
 

DANGER:  NEVER ADD FUEL TO A HOT MACHINE 
OR RUNNING MACHINE. HOT ENGINE PARTS 
SPARKS, OR LIT CIGARETTES COULD IGNITE 

GASOLINE. NEVER STORE FUEL OR OTHER 
COMBUSTIBLE MATERIAL NEAR THIS MACHINE. 

 
 

SAFETY RULES 

 

DANGER

: This equipment produces a very high 

pressure stream of water which can penetrate 
the skin and cause serious injury. Under no 

circumstance should the spray gun be aimed at people, 
animals or any delicate items which might be damaged. 

 

DANGER:

 Users of this machine should always 

dress properly before using. Safety glasses, 
shoes, long pants, shirt, and ear protection are 

recommended. Specific situations, such as during 
chemical application, could require a much greater level 
of protective clothing. 

 

DANGER

: When using chemicals in conjunction 

with this machine you should always wear gloves, 
eye protection and clothing which leaves no 

exposed skin. 

 

DANGER:

 Never point the output water stream 

at electrical wiring or devices. This can lead to 
damaged components, personal injury or even 

fatal electrical shock. 

 

CAUTION:

 Do not modify the factory engine 

settings on your pressure washer. The factory 
settings are made to produce the designed 

pressure and flow rate for your equipment. Any 
misapplication can lead to damaged components or even 
bodily injury. 

 

CAUTION:

 Only qualified personnel should be 

allowed to use this machine. Under no 
circumstances should children be allowed to 

operate this machine. 

 

CAUTION:

 The water supply should always be 

clean. Never use water if it contains dirt, sand, 

chemicals or any other foreign matter.  For information 
regarding chemical use refer to the section titled Chemical 
Application included later in this manual. 

 

Summary of Contents for LD20



















Reviews: