Assembly of small drawer
Drawer’s bottom
Bend 90°
Bend
Front
panel
hook
View A
A
Front panel
Drawer’s
bottom
groove
End cap
Drawer’s bottom
Back panel
1
2
2
1
Front panel
2
1
3
х 4
5
7
Installation of drawer into cabinet
Bracket
Partition
Bracket
Spring rod
Side
panel
Bracket
Side
panel
2
1
8
х 4
Installation procedure of bracket:
1. Insert the rods into the holes of the side panel until it stops
2. Bring the bracket’s front part to the side panel, “drown” the rods
and mount the bracket. The rods should “click” in the side panel’s
holes.
Note.
1. Before the bracket installation, make sure that the rods go
freely into the holes, and if it’s necessary (a rod doesn’t go
into), clean the holes of the paint.
9
Tool Cabinet TC
10
Installation of bracket on side panel
Installation of bracket on partition
х 4
х 4
Installation procedure of brackets:
1. Install the bracket on the partition so
that the holes on it and on the partition
match each other.
2. Tighten the bolts as it’s shown on the
picture
Bracket
Pic.А
Straighten, if bracket’s sides
are kinked
Bend, if bracket’s sides are
not completely bent
2. Also there is a possibility of mismatch of the rods with the holes in the side panels if the bracket’s
panels are kinked or not completely bent. Thus, if it’s necessary, bend or straighten the brackets in
the rods’ area. (see pic.A)
grooves under hooks of right slide
grooves under hooks of left slide
Top
2
1
Spring
pin
Bracket
of drawer
Attention: The correct position of the
bracket in the cabinet – the grooves
on the bracket’s sides must be on the
top.
Top
1
2
lock
Dismantling of ball-bearing slide
1. Pull out the slide until it stops
2. Turn the plastic lock back
3. Fully pull out the slide’s element
х 2
4
6
installation of the slide’s element onto the drawer
grooves under slide’s hooks
View А
hook
hook
View B
B
А
drawer with installed elements
1
2
