Points for Attention
●
Mount the elbow tube to the hose
●
Mount the hose to the tank
Hold on the hose connector and insert it into the inlet opening.and
make sure that the bayonet couplers catch their tracks. Then push
forward and turn clockwise until the coupling locks. When
disassembling the hose turn counterclockwise and pull it out.
（
F
●
Do not let this vacuum cleaner near the furnace and
subject with higher temperature in order to avoid plastic
deformation and damage. (Fig.1)
●
Avoid bending, stamping and dragging the hose. Do
not use the vacuum cleaner when hose damaged.
（
Fig.2
）
●
Please disconnect the power cord plug when you don
’
t use the vacuum cleaner, as well as for maintenance
work and cleaning. Please hold on the plug and do not
drag the power cord while inserting and plugging the
cord.
（
Fig.3
）
●
Before using the vacuum cleaner, please check if
filter, filter sponge, paper bag or cloth bag are properly
mounted. please don
’
t use the vacuum cleaner when
above parts do not exist.
（
Fig.4
）
Mounting the assembly
When connecting insert the elbow tube into the bigger hole of the
extension tube then swivel it to firm connection. (Fig.9)
●
The method of connecting the extension tubes is the same at above
(you can use one extension tube or two).
●
Amount the extension tube to the floor nozzle
When connecting insert the smaller end of the extension tube into the
floor nozzle than swivel it to frim connection. (Fig.10)
1
2
3
8
9
10
接管
地面 刷
Begin to use
●
Power cord
Crank
●
When using the vacuum cleaner, do not
absorb hair group, large ball of paper and
other items that may make the absorbing
inlet, tube and hose get blocked. Otherwise
it may cause malfunction or deformation. If
these items were absorbed please disconnect
●
Please use a cloth dampened with water or mild soap
for cleaning the vacuum cleaner. Do not use gasoline,
banana oil, otherwise it will lead to crack or fade.
（
Fig.7
）
Connection method for crevice nozzle and upholstery brush is the
same as above.
●
While absorbing please do not absorb mud, gypsum
material, wall powder etc. otherwise the vacuum cleaner
filter can cause blockage and the motor will be burned. If
these small particles were absorbed please clean the dust
bag or filter.
（
Fig.6
）
above parts do not exist.
（
Fig.4
）
The effective length of power cord is 4 meters.
Unplug the plug from the socket when you have finished using it and
rewind the power cord with the crank into the winding roll inside the
vacuum cleaner.(Fig.11)
●
Power source
After inserting the plug into the power socket, press the position "1" or
the green switch the vacuum cleaner will work. Press the position "0"
or the red switch the vacuum cleaner will stop working.
4
6
7
10
11
12
5
