9/26
Press button ENTER to confirm; after powered on next time, the default will be last value saved
Press button FUNC, it will return to the upper menu
.
●
DMX WIRELESS CONTROL
(If the projector has the function)
The projector has wireless control function with wireless receiver module and antenna for remote control.
The setup of it is below:
1.
Enter into the projector
’
s menu. Select the menu
“
Config Settigns
”
via the bottoms of
UP and DOWN
2.
Select
DMX control Mode
----
Wireless First
(Note: do not select
XLR ONLY),
then wireless indication in the
front panel will be on, meaning wireless control function is activated.
Only after the projector is linked with a transmitter, can it receive wireless signal sent by the transmitter. If unlinking it,
Press
“
Enter
”
for the menu of Unlink Wireless under the upper level menu of Config Settigns .
●
STAND-ALONE MODE
Operate the projector without connecting with a controller, enable the master mode through the operation panel, the
projector will run in Stand-Alone mode automatically.
DMX address can be set at any number within 512
.
●
MASTER/SLAVE MODE
Many projectors can run synchronously in the Master/Slave mode by linking them with each other. First,
connect the first fixture
’
s DMX output to the second fixture
’
s DMX input using XLR-XLR control cable and then connect the second
fixture
’
s DMX output to the third fixture
’
s DMX input, and so on until all projector are connected in this way. Eventually connect the
last fixture
’
s DMX output to a DMX terminator. Set 1
st
projector as the master and others are Slaves.
Start Addresses of all Slaves are 001; Operation mode of the Master can be set any mode for a Master
’
and Slaves
’
operation mode can
be set accordingly.
After Powered on, the group will run in Master/Slave Mode
TO CONTROLLER
DMX512
DMX IN
DMX OUT
TO TERMINATER
DMX IN
DMX OUT
DMX IN
DMX OUT
