PR Lighting XLED 1037 PR-8120, User Manual, Page: 6 / 16

6/16
2
1
3
120
DMX TERMINATOR
CONNECTION
Connect a 120 (OHM) resistor
across pins 2 and 3 in an XLR plug
and insert into the DMX out socket
on the last unit in the chain.
PIN 3
PIN 2
SETUP OPTIONS-PROJECTOR CONFIGURATION
Projector configuration can be set conveniently via press button switch and LCD display.
To browse or change its setup options, Press button ENTER more than 3 seconds to unlock panel. Menu will be displayed on the
screen, each menu has it own sub-menu. Each menu has specific function, Please refer to “Operation Menu” for details.
Press button UP or DOWN if you want to browse or change through the various Setup Options.
Press button ENTER to save your settings or enter the next menu.
Press button UP or DOWN to change values.(Add or subtract)
Press button FUNC, it will return to the upper menu one by one.
TO SET THE DMX START ADDRESS
Each projector must be given a DMX start address so that the correct projector responds to the correct control signals. This DMX start
address is the channel number from which the projector starts to “listen” to the digital control information being sent out from the
controller. The fixture have 2 DMX modes. There are standard mode and extended mode. For example standard mode has 17
channels, so set the No. 1 projector’s address 001, No. 2 projector’s address 018, No. 3 projector’s address 035, No. 4 projector’s
address 052 and so on.
Launch the projector. Press button ENTER more than 3 seconds to unlock panel.
Press button ENTER to display
DMX address
;
Press button UP and DOWN, you can set the address;
Press button ENTER to confirm while Green Indication flashes, which means the projector has saved the Start Address automatically,
when powered on next time, it will display the value saved last time.
Press button FUNC, it will return to the upper menu one by one.