PR Lighting PR-2927, User Manual

Page: 10 / 28

10
●
STAND-ALONE MODE
Operate the projector without connecting with a controller, enable the master mode through the operation panel, the
projector will run in Stand-Alone mode automatically.
DMX address can be set at any number within 512.
●
MASTER/SLAVE MODE
Many projectors can run synchronously in the Master/Slave mode by linking them with each other. First,
connect the first fixture’s DMX output to the second fixture’s DMX input using XLR-XLR control cable and then connect the second
fixture’s DMX output to the third fixture’s DMX input, and so on until all projector are connected in this way. Eventually connect the
last fixture’s DMX output to a DMX terminator. Set 1
st
projector as the master and others are Slaves.
Start Addresses of all Slaves are 001; Operation mode of the Master can be set any mode for a Master’ and Slaves’ operation mode can
be set accordingly.
After Powered on, the group will run in Master/Slave Mode
6. OPERATION MENU
1st LEVEL 2nd LEVEL 3rd LEVEL 4th LEVEL 5th LEVEL
Address
DMX Address
1-476
IP Address
Default IP Address 2.X.X.X /10.X.X.X
Custom IP Address X.X.X.X
SubNet Mask
X.X.X.X
ArtNet Universe
0-255
Reset
Total Reset Really Reset?
Pan&Tilt Reset Really Reset?
Colour System Reset
?
Really Reset?
Gobo Reset Really Reset?
Dimmer/Strobereset Really Reset?
Zo.Fo.Fr.Pr. Reset
?
Really Reset?
Other Reset Really Reset?
Config Settings
DMX Channel Mode
Short Mode
Standard Mode
Extended Mode
View Selected Mode
Lamp Control
Lamp Control
OFF/ ON
On By Power On OFF/ ON
Control By DMX OFF/ ON
Lamp Power
( W )
1200/1400
1200/ 1400
Signal Select
Master Slave
DMX
Terminator DMX
Controler
Slave