PR Lighting PR-2554, User Manual

Page: 8 / 28

8
●
ALIGNMENT/INSTALLATION/REPLACEMENT OF A LAMP
Lock the yoke before fitting/replacingthe lamp. Just as Shown by Figure 1, after Opening the cover at the rear of the projector by
loosening 8 fastfit screws, you can open the head. To adjust the lamp as per Figure 2. Take out the lamp as per the figure 3.
Before lamp installation, tighten its power wires well. Lamp in and out are opposite orders
●
Don’t touch the internal surface of the reflector and the burner of the lamp with bare hands so as not to
impair the beam output. While lamp’s installation, do not damage the metal wire around the burner.
●
Please read "Instructions " enclosed with the lamp
●
Do operate the projector while adjusting the lamp
●
GOBO REPLACEMENT
DANGER!
Before replacement of gobos, the projector must be off the power.