Figure3: removal of lamp
9/34
●
GOBO REPLACEMENT
DANGER!
Before replacement of gobos, the projector must be off the power.
2.unplug two lamp wires
Remove obliquely the lamp before
pushing it up
1.loosen a tightening screw @ the
lamp's side
Figure 2
Figure 2
Rotating gobo wheel
Rotator
Gobo
Tightening
spring
Gobo replacement
1. As shown in figure1, disconnect a projector from power. Unfasten
the 4 fastfit screws of the cover to remove the cover, and unfasten
the 2 screws of the fan assembly and remove the assembly.
2.Pull out the rotator from the rotating gobo wheel forcefully by
fingers as shown in figure2 After replacing the gobo or the rotator,
put the rotator back to the holder.
unfasten 2
screws using a
cross screw
driver
remove the fan
component
Figure 1